Announcements
Welcome!
Welcome to the Fall 2025 course page for CSCI1600! To be fully enrolled in the class, you should register for one of the two lab sessions. The first lab will be on Monday (September 8) and Tuesday (September 9).
Course supplies: No textbook needs to be purchased for the course, but you do need to acquire an Arduino Uno R4 WiFi and an electronics kit that has at least the components listed below. Both are sold at the bookstore. If you would like to purchase them online, here is the Arduino link. The bookstore stocks the ELEGOO kit with 235 components, but any similar kit with at least the component below will do (check with the course staff if you’re not sure!). Note that you cannot substitute another type of Arduino (including the MKR1000 used previous years), because some of the labs depend on the hardware of the chip.
Kit components used in labs (along with Arduino Uno R4 WiFi + cable):
- Breadboard
- Assorted LEDs
- Assorted resistors
- Jumpers/wires
- 100uF capacitor
- RGB LED
- Push buttons (2)
- Potentiometer
- Passive piezo speaker
For more information on what these look like, check out the component glossary
All remaining course announcements will be made through the EdSTEM board